Raven Cruizer II Operator's Manual download pdf (Page 94)

Chapter 11

88 SmartBoom and SmartRow Installation and Operation Manual

Mechanical Problems

Mechanical problems with the vehicle can cause the SmartBoom/SmartRow to not work properly.

Before you start troubleshooting the system, trace all hoses and wires to make sure that they are

connected to the proper ports and connectors. You can avoid many potential problems by making sure

that all wires and hoses are properly connected.The following table lists some common problems and

the corrective action needed to fix the problem.

Lo Mem or

LoDMem

Less than 20% of

memory left

• Finish job and start new job.

Flash?

An error has

occurred writing to

the flash card

• If this problem persists, your unit will

need to be returned for repair.

NoCons

SmartBoom/

SmartRow cannot

communicate with

the console

• Check console data cable. If console

does not support serial

communication then set SmartBoom

console port to NONE through

System Config menus.

Dashes

Master switch in off

position

• Turn on master switch.

O in boom position

Boom switch out of

position

Override Enabled

• Turn all console or machine boom

switches to the off position.

• Override should time out.

Problem Solution

SmartBoom/SmartRow will not

power up

• Turn the key to the On position.

• Turn the product controller power

switch to on.

• Check the fuses.

• Check the battery connections.

• Test for +12VDC using a voltmeter.

• Replace SmartBoom/SmartRow.

SmartBoom/SmartRow displays

only half of the screen.

• Unplug the power cable from the back

of the controller and then reattach it

and power up.

• Replace SmartBoom/SmartRow.

Error Messages Problem Solution

1 2 ... 89 90 91 92 93 94 95 96 97 98

Comments to this Manuals

No comments

Raven Cruizer II Operator's Manual Page 94

Comments to this Manuals

Related products and manuals for Navigators Raven Cruizer II