Raven Cruizer II Operator's Manual download pdf (Page 87)

Manual No. 016-0171-093 81

SmartRow Cruizer Interface and Calibration

SmartRow Modes

The available modes for operating SmartRow are:

• Standard SmartRow Job

• SmartRow Job with No Plant Zone

• SmartRow Job with Field Boundary

• SmartRow Job with Field Boundary and No Plant Zone

Standard SmartRow Job

As sections enter previously painted areas, SmartRow automatically turns that section OFF. When the

section leaves the previously painted area, SmartRow automatically turns the section back ON.

The standard field boundary tools are used while operating in Standard SmartRow Mode.

No Plant Zone Mapping Mode

No Plant zones may be created and around any areas in which product application should be avoided,

such as waterways or around well heads.

For example, as the vehicle crosses into a no plant zone, SmartRow automatically shuts off any

section that enters the no plant zone while other sections remain enabled. As the sections reenter un-

painted zones, SmartRow automatically toggles product application back on.

Field Boundaries

Field Boundaries within a SmartRow enabled Job automatically create a zone map based upon the

completed boundary.

SmartRow assigns a minimum of three implement widths outside of the completed field boundary of a

plant zone.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 97 98

No comments

Raven Cruizer II Operator's Manual Page 87