Raven Cruizer II Operator's Manual download pdf (Page 66)

Chapter 8

60 SmartBoom and SmartRow Installation and Operation Manual

Master Switch Screen

To get to the Master Switch screen, press from the Console Port screen.

The Master Switch screen allows the operator to configure the Master Switch that will enable or

disable SmartBoom boom section control.

Press to edit the Master Switch setting. The setting will begin blinking to indicate you are in edit

mode. Use the or key to toggle between “External” or “Enter Key.” Press the key again

to finish editing. The default setting is “External”. When set to “Enter Key,” the operator can enable

SmartBoom from the Home screen by pressing the key.

When set to “External” and when using a Raven console such as the SCS 440 or 4400, SmartBoom

will sense the master switch on the console via the SmartBoom/SmartRow interface cable. If you are

using SmartBoom without a Raven console, the orange wire with white stripe must be tied into an

external switch to enable/disable SmartBoom.

Master Switch

External

RAVEN

HOME

INDUSTRIES

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 97 98

No comments

Raven Cruizer II Operator's Manual Page 66