Manual No. 016-0171-093 5
CHAPTER
3
CH A PTE R 3
SmartBoom/
SmartRow Installation
Mounting
1. Mount the SmartBoom/SmartRow controller using the elongated holes in the flange assembly.
2. Tighten the support screws securely to prevent jarring or bouncing of the SmartBoom/SmartRow
controller.
FIGURE 1. SmartBoom/SmartRow Console
Power
The SmartBoom/SmartRow controller is powered through the SCS console. The controller will power
up when the console is switched On.
Connect the 4 pin power connector from the SmartBoom/SmartRow Interface Cable to the 4 pin port
on the back of SmartBoom/SmartRow. SmartBoom/SmartRow should receive between 9 and 16 Volts.
Comments to this Manuals