Raven Cruizer II Operator's Manual download pdf (Page 30)

Chapter 6

24 SmartBoom and SmartRow Installation and Operation Manual

6. Configure the Implement Locations - If this is a standard configuration, use the SmartRow

Autoloaded feature to configure the location of each section with respect to the GPS antenna. If a

custom configuration is used, use the optional boom configuration screens to set the location of

each boom section with respect to the GPS Antenna.

FIGURE 1. Section Location Example

7. Set the Look Ahead Times - Use the SmartRow Configuration menus to set the Turn On and Turn

Off Look Ahead Times. The default setting is 0.1 seconds.

8. Set the Override Time - Use the SmartRow Configuration menus to set the Override Time. The

default setting is 5 seconds.

9. Set the Percent Coverage - Use the SmartRow Configuration menus to set the Percentage

Coverage. The default setting is 100 percent.

10. Select The Booms To Be Controlled - Use the SmartRow Configuration menus to select which

booms will be controlled by SmartRow. The default setting allows SmartRow to control all boom

sections.

About SmartRow Jobs

SmartRow provides several methods of operation. These include:

• Standard Job

• Job with field boundary

• Job with no plant zones

• Job with field boundary and no plant zones

2 3

Section 1

GPS Antenna

Fore/Aft

Left/Right

Section

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 97 98

No comments

Raven Cruizer II Operator's Manual Page 30