Raven Cruizer II Operator's Manual download pdf (Page 84)

Chapter 10

78 SmartBoom and SmartRow Installation and Operation Manual

Planter Controller Setup Screen

From the Planter screen, touch the Planter Controller Setup Icon in the lower left corner to access

the Controller Setup screen.

The Planter Controller Setup screen allows you to set up SmartRow control parameters for the job you

are working on. Under most conditions, these settings will be set and not changed.

The Section control allows you to individually enable SmartRow control for different section numbers.

Select electric clutch for electric clutch systems and leave unchecked for pneumatic (air) systems.

Touch the Alarms Icon to toggle the alarms on and off.

Touch the Test Icon to test cycle the sections. Each section will individually turn on for 4 seconds and

then turn off. The next section will then be turned on and off and the process will continue until every

sections has been cycled on and off.

Touch the Check Mark to return to the planter screen or touch the Home Icon to return to the home

screen

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 97 98

No comments

Raven Cruizer II Operator's Manual Page 84