Raven Envizio Pro Technical Information download pdf (Page 14)

AutoBoom™

The following sections offer an overview of setting up and using an optional Glide

Series AutoBoom™ system with the Envizio Pro. Refer to the AutoBoom

Calibration & Operation manual for detailed setup and calibration information

regarding the AutoBoom™ system.

To view the Glide Series AutoBoom settings and to enable automatic boom height

control, touch , then and to access the Glide Series AutoBoom

setup screens.

Enabling AutoBoom While Staring a Job

1. Touch the icon on the home screen and touch the AutoBoom button on the

Start Job - Verify Settings screen.

2. Select the Enable AutoBoom option and touch the icon.

3. Complete the procedure in the Start a Job section earlier in this guide and

select the to begin guidance.

4. Before guidance will begin, the operator will be prompted to review the Glide

Series AutoBoom system settings.

The Envizio Pro will display the configuration screen for your Glide Series

AutoBoom™ system. This configuration screen will look similar to the following:

5. If is displayed in the upper right corner, touch the icon to toggle the

AutoBoom system on.

6. Touch the Left or Right Boom Disabled button to toggle automated boom

height control for each boom.

Warning: Booms may raise and lower unexpectedly. Make sure the area

around the booms is clear of obstructions and people before touching these

buttons.

7. Touch if system adjustments are necessary, or to fine tune the

AutoBoom™ system.

8. Touch the icon to open the job and begin guidance.

1 2 ... 9 10 11 12 13 14 15 16

No comments

Raven Envizio Pro Technical Information Page 14