Raven 210LB User Manual download pdf (Page 14)

Navigation Aid System Setup and Operation Manual

Page 14 of 21

3. Using a clamp mount or a magnetic mount, position the antenna on the bridge wing where it has

an unobstructed view of the sky.

Figure 12: Correct Antenna Mounting Using Clamp

4. Turn on the power to the 210LB/Battery box by pressing the power button. (Make sure that you

keep the battery charged with the charger that comes with the system. See section 8.3 - Charging

the Battery.

5. Setup the BPI as described earlier in this manual.

6. On the laptop computer, start the Raven navigation software, usually Wheelhouse II (WHII).

8.2 Pack-Up Steps

Pack up the system in the reverse set up order. It is very important that the power supply be unplugged

before any other wires are disconnected. In general:

1. Shut down the computer.

2. Unplug the computer.

3. Turn off the power of the 210LB/Battery.

4. Disconnect the antenna cable.

5. Roll up the antenna cable.

6. Disconnect, turn off, and pack the BPI.

7. Do not store the computer in a very hot or cold location. Do not leave the computer in a car trunk

over night.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Raven 210LB User Manual Page 14